StarTech.com SM21BMU31CI3 Bruksanvisning

Läs gratis den bruksanvisning för StarTech.com SM21BMU31CI3 (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 16 personer och har ett genomsnittsbetyg på 4.8 stjärnor baserat på 4 recensioner. Har du en fråga om StarTech.com SM21BMU31CI3 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Quick-Start Guide

To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.

Manual Revision: May 15, 2019 2:18 PM

Product Diagram (SM21BMU31CI3)

Exterior

ComponentFunction

1Drive-Tray Screws x 2

• Used to secure the in the Drive Tray

Enclosure.

2USB-C Cable

• Used to connect the to the Enclosure Host

Computer.

Interior

ComponentFunction

1

M.2 NGFF B Key Drive

Connector

• Used to connect the to the .DriveEnclosure

2

Drive Length Holes

(x 2)

• Used to accommodate dierent drive lengths

(42 mm, 60 mm and 80 mm).

3

Drive-Mount Screw/

Nut

• Used to secure the to the .DriveEnclosure

M.2 NGFF SATA Enclosure | USB-C | USB 3.1 (10Gbps)

1

4

Stando (not

displayed)

• Used to secure the to the DriveEnclosure

using either the 42 mm or 60 mm Drive

Length Holes.

Requirements

For the latest requirements, please visit www.startech.com/SM21BMU31CI3

• An available USB-C Port

• An M.2 NGFF SATA SSD

Installation

Installing a Drive

Warning! Drives should be handled carefully, especially when they’re transported. If

you’re not careful with your drives, you may lose data as a result.

1. Use a (included) to remove the (x 2) Phillips Head Screwdriver Drive-Tray Screws

from the . Enclosure

2. Carefully pull the out of the . Drive TrayEnclosure

3. Place the beside the and align the screw groove on the with DriveDrive TrayDrive

the on the .Adjustable Drive Length HolesDrive Tray

4. Use a to remove the .Phillips Head Screwdriver Drive-Mount Screw

Note: If the drive-mount hardware is already installed in the correct position, proceed

to step 9.

5. Align the with the correct according to the length of Stando Drive Length Hole

the .Drive

6. Insert the into the large part of the .StandoDrive Length Hole

Note: Make sure that the longer part of the stando is on the same side as the M.2

NGFF B Key Drive Connector.

7. Align the notches on the with the edges of the smaller part of the StandoDrive

Length Hole.

8. Slide the into the smaller part of the .Stando Drive Length Hole

9. Gently slide the connector on the (on a 30-degree angle) into the DriveM.2 NGFF B

Key Drive ConnectorEnclosure on the .

Note: Do not force the Drive into the enclosure, the connector on your drive is keyed so

that it only ts one way.

2

1

2

3

Produktspecifikationer