STI -9845 Bruksanvisning

STI Detektor -9845

Läs gratis den bruksanvisning för STI -9845 (1 sidor) i kategorin Detektor. Guiden har ansetts hjälpsam av 3 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 2 recensioner. Har du en fråga om STI -9845 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/1
INSTALLATION OF STI-9845 XTRALIS OSID DETECTOR WIRE GUARD
All specifications and information shown were current as of publication and are subject to change without notice.
9845 DEC2019
RECOMMENDED CLAMP PLACEMENT AS SHOWN
19013 #10 x 1 1/2 in.
SCREW (4) PROVIDED
USING DRILL 1/4 in. (6.3mm) DIAMETER HOLES
RAWL PLUGS (4) PROVIDED
AREA OPEN FOR
CONDUIT ACCESS
19020 HINGE CLAMP
(4) PROVIDED
104mm
(4.07 in.)
234mm
(9.2 in.)
167mm
(6.7 in.)
XTRALIS OSID DETECTOR
Web: www.sti-usa.com • E-mail: info@sti-usa.com
USA - Headquarters
2306 Airport Road • Waterford, Michigan 48327-1209
Phone: 248-673-9898 • Fax: 248-673-1246
Tel: 44 (0) 1527 520 999 Fax: 44 (0) 1527 501 999
E-mail: info@sti-emea.com • Web: www.sti-emea.com
European Office
Taylor House • 34 Sherwood Road Bromsgrove
Worcestershire • B60 3DR • England
INSTALLATION INSTRUCTIONS:
1. Centre wire guard over device as shown.
2. Place hinge clamp in upper right position.
3. Mark and drill ¼” diameter hole.
4. Mount wire guard over device using right hinge clamp and tighten screw.
This should hold wire guard in place. Mark and drill the remaining 3
clamp holes (if necessary, loosen upper right clamp screw and remove
wire guard).
5. Mount wire guard, all 4 clamps and screws. Tighten firmly.

Produktspecifikationer

Varumärke: STI
Kategori: Detektor
Modell: -9845

Behöver du hjälp?

Om du behöver hjälp med STI -9845 ställ en fråga nedan och andra användare kommer att svara dig