Vemer LPG Sensor Bruksanvisning

Sidor 1 Engelska Inte kategoriserad

Läs bruksanvisningen för Vemer LPG Sensor gratis online eller ladda ner PDF:en. Bruksanvisningen har visats 20 gånger. Fråga om modellen? Ställ en fråga

Ladda ner PDF (0.3 MB) Specifikationer

V3IS00462-010

CH4 SensorCO SensorLPG Sensor, and areprobesforthedetectionof

methanegas,carbonmonoxideandLPGtobeconnectedtoSRG and SRG.4

controlunitstocreatesystemsfordetectinggasinareassuchasboilerrooms,

warehouses,etc.

It is wall-mounted in a vertical position using screws and plastic plugs.

SAFETY WARNINGS

During installation and operation of the instrument, comply with the

following instructions:

1) The device must be installed by a competent person

2) Before removing the cover, make sure that power is NOT provided to

the device

3) Before accessing the terminals, make sure that the electrical leads are

not live

4) Install the detector in the correct position (see “Installation”)

5) Do not power on the device if any part of it is damaged

Code Model Description

VE205100CH4SENSORMethanedetectionsensor

VE206900 LPG SENSOR LPG sensor

VE207700 CO SENSORCarbonmonoxidesensor

TECHNICAL CHARACTERISTICS

•Powersupply:fromthecontrolunitSRGorSRG.4

−Currentinput(at6.5V):40mA

−Connection:terminalsof2.5mm

C(common),S(signal),A(powersupply)

•Modelsandcalibration:

−Methanegas:CH4Sensor,(default)10%LIEofmethane

−LPG:LPGSensor,(default)12%LIEofisobutene

−Carbonmonoxide:COSensor,(default)200ppmofcarbonmonoxide

•Max.lengthofconnection:50m

•Container:inself-extinguishingplasticmaterial

•Fastenedtowallusingscrewsandplasticplugs

•Protection:IP30

•Operatingtemperature:0÷+50°C

•Humidity:90%R.H.withoutcondensation≤

INSTALLATION

LPG,COandCH4Sensorsaredesignedtobewall-mounted(vertically),using

screwsandplasticplugs.Toproceedwithinstallation,openthecontainerby

unscrewingthescrewlocatedonthelowerside.Makesurenottodamagethe

sensorandnottotouchthecalibrationdevices.

POSITIONING

Thecorrectinstallationoftheprobeisessentialtoproperoperationofthe

system.Therefore,itmustbeinstalled:

•Inareaswithcirculationofnaturalair;

•Inareasthatarenotsubjecttodustordirtthatmayrenderthesensor

inoperative;

•Nearjetsofwater,intakegrilles,openings,etc.

•Atanadequatedistancefromusersofgassoastopreventthesystemfrom

interveningimproperlyduetofunctionalleakage.

Also,positioningdependsonthetypeofgastobedetected,specically:

•CH4 Sensor: Methane gas – at top, about 20-30 cm from the ceiling

•LPG Sensor: LPG – at bottom, about 20-30 cm from the ﬂoor

•CO Sensor: carbon monoxide – about 1.5 m from the ﬂoor

Fornewsystems,theprobemustbeinstalledaslateaspossible,sothattypical

constructionsiteactivitiesdonotdamagethedetector.

CONNECTIONS

Normalelectricalcablescanbeusedforconnections.Inanycase,when

installationisinplacesthatarestronglyexposedtoelectromagnetic

disturbances,itisadvisabletouseshieldedcables.Thedetectionsystemmust

alwaysbeinoperation.Therefore,theelectricalpowersupplyofthedetector

mustnotincludeswitchesorotherdevicesthatmayaccidentallyshutitoff.The

averagelifespanoftheprobesis5yearsfromthedateofinstallation.Therefore,

attheendofthattimetheywillneedtobereplaced.

Note. Make sure you check operation at least once a year, and in any

case whenever there is an extended period of disuse or in the event of

replacement. Any tampering may compromise correct operation of the

system.

REFERENCE STANDARDS

CompliancewithCommunityDirectives:

2006/95/EC (lowvoltage)

89/336/EECmod.fromandfrom92/31/EEC 93/68/EEC(E.M.C.)

isdeclaredwithreferencetothefollowingstandards:

EN 61779-4, EN 50270

User Manual

SENSORS FOR SRG/SRG.4 CONTROL UNITS

Read all the instructions carefully

Dimensions

Connection diagrams

119,0

75,3

36,0

CH4 SENSOR

CSA

SRG/SRG.4

Mod. CH4 SENSOR

Mod. LPG SENSOR

Mod. CO SENSOR

Betygsätt denna manual

Produktspecifikationer

Varumärke:	Vemer
Kategori:	Inte kategoriserad
Modell:	LPG Sensor
Vikt:	117 g
Bredd:	1000 mm
Djup:	69.85 mm
Höjd:	9.5 mm
Snäll:	Hybride hdd
Snabbstartsguide:	Ja
Gränssnitt:	SATA III
Hållbarhetscertifikat:	RoHS
siffra:	1
HDD kapacitet:	1000 GB
HDD rotationshastighet:	5400 RPM
HDD storlek:	2.5 "
Driftspänning:	5 V
Harmoniserad systemkod (HS):	84717050
Storlek på lagringsenhetsbuffert:	64 MB
Genomsnittlig väntetid:	5.56 ms
Hybride HDD (H-HDD) cacheminne:	8 GB
Överdragshastighet HDD-gränssnitt:	6 Gbit/s

Behöver du hjälp?

Om du behöver hjälp med Vemer LPG Sensor ställ en fråga nedan och andra användare kommer att svara dig

Vemer LPG Sensor Bruksanvisning

Produktspecifikationer

Behöver du hjälp?

Fler manualer från Vemer

Andra märken