Alula RE218T Bruksanvisning

Läs gratis den bruksanvisning för Alula RE218T (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 37 personer och har ett genomsnittsbetyg på 4.1 stjärnor baserat på 9 recensioner. Har du en fråga om Alula RE218T eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Flood and Temp Sensor is an integrated environmental

sensor. It detects ood conditions and reports extreme

temperatures.

Features

• Titanium probes for unmatched corrosion immunity

• IP67 rated waterproof enclosure

• GORE

®

vent to prevent seal failure

• 5 year warranty

Enroll by placing the panel into wireless enrollment mode and

removing the battery tabs, tampering the sensor, or manually

entering the sensor ID. NOTE, this sensor requires rmware

version 1.14 or later for GC2 Panel and 3.1 or later for

CG3. For older panel rmware versions, use the RE218

Honeywell

®

Compatible Flood and Temp Sensor.

Panel QuestionsFloodHeatFreeze

Sensor Type

[08] 24 Hour

Aux. Alarm

[08] 24 Hour

Aux. Alarm

[08] 24 Hour

Aux. Alarm

Equipment Type[8] Water[10] Temp.[6] Freeze

Equipment Code

[1065] 2GIG

Flood Sensor

[1065] 2GIG

Flood Sensor

[1065] 2GIG

Flood Sensor

Sensor Age[0] New[0] New[0] New

Loop Number[1] Flood[2] Heat[3] Freeze

Install by placing the sensor in the location requiring ood or

temperature detection. If desired, the wall clip can be used

to secure the sensor.

Optional Screw Mounting

• Remove the wall clip from the sensor body.

• Secure the clip to a wall, baseboard or cupboard

using a #6 screw.

• Slide the sensor body down onto the wall clip until

it snaps into place.

Sensor detects water pooled under the sensor and reports

extreme temperature conditions.

Temperature Trip Points

• Heat alarms when over 100°F (38°C)

• Heat restores when under 97°F (36°C)

• Freeze alarms when under 45°F (7°C)

• Freeze restores when over 48°F (9°C)

To replace the batteries, insert a at blade screwdriver into

the front slot and twist. Slide both old batteries out and the

new batteries in. To reinstall the cover, align the rear latches

and roll the cover forward until it snaps into place.

I

N

S

T

A

L

L

G

U

I

D

E

I

Verify proper enrollment and operation using your control panel’s installation manual.

Front slot

Mounting Screw Hole

Wall Clip

RE218T Flood & Temp Sensor

2GIG

™

Compatible

Resolution Compatibles

Produktspecifikationer