Doepfer A-143-3 Bruksanvisning


Läs gratis den bruksanvisning för Doepfer A-143-3 (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 26 personer och har ett genomsnittsbetyg på 4.0 stjärnor baserat på 13.5 recensioner. Har du en fråga om Doepfer A-143-3 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/4
DOEPFERDOEPFERDOEPFERDOEPFER System A-100 Quad LFO A-143-3
1
Fig. 1: A-143-3 Controls and Outputs
1. Introduction
Module A-143-3 Quad LFO is a low-cost four-fold
modulation oscillator and includes four independent low
frequency oscillators (LFO's), which produce cyclical
control voltages in a wide frequency range.
Three waveforms are available for each LFO: triangle,
square and sawtooth. The frequency of the sawtooth
output is twice the frequency of the other outputs.
The LFO's can be used as modulation sources for any
control voltage input of other modules - for instance
modulating the pulse width or frequency of a VCO,
modulating the cut-off frequency of a VCF or the phase-shift
of a VCP, amplitude modulation with a VCA, delay time of a
BBD module, parameters of a voltage controlled wave
shaper/multiplier, or any other control voltage input.
A three-way switch let’s you select three frequency ranges,
spanning from about two cycles per minute at the lowest, to
moderate audio frequency at the highest.
The module includes four identical units.


Produktspecifikationer

Varumärke: Doepfer
Kategori: Inte kategoriserad
Modell: A-143-3

Behöver du hjälp?

Om du behöver hjälp med Doepfer A-143-3 ställ en fråga nedan och andra användare kommer att svara dig