Liftmaster CAPXLTK Bruksanvisning

Läs gratis den bruksanvisning för Liftmaster CAPXLTK (4 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 20 personer och har ett genomsnittsbetyg på 4.1 stjärnor baserat på 5 recensioner. Har du en fråga om Liftmaster CAPXLTK eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

BACK BOX AND TRIM KIT

MODEL CAPXLTK

INTRODUCTION

The CAPXLTK back box and trim kit allows you to fl ush

mount an CAPXL/CAPXLV unit into a cutout of a wall (or

other fl at surface). The CAPXLTK is used for new installations

or retrofi ts ELITE Icon26 and Sentex Infi nity L systems.

INSTALLATION

1. Cut a hole in the wall to accommodate the back box of the trim kit

(back box dimensions: 18-1/2" x 14-13/16" [47 cm x 37.6 cm]).

2. Separate the trim plate from the back box by carefully pulling the trim

plate away from the back box.

3. Place the back box into the cutout. Use metal shims or hold the box

level while marking the mounting holes through the side brackets.

4. Fasten the back box and side bracket assembly to the wall or mounting

surface.

5. Snap the trim plate onto the back box ensuring the slots in the trim

plate are fully engaged with the screw heads.

6. Remove the four mounting knockouts found on the rear face of the

CAPXL/CAPXLV back box.

7. Install the CAPXL/CAPXLV using Phillips head screws 6-32 x .25" (4)

and #8 lock washers (4)(not provided).

Carton Inventory: Back box assembly, trim plate, instructions.

Additional Items You May Need: Phillips head screws 6-32 x .25" (4) and

#8 lock washers (4).

Trim Plate

Side

Bracket

Side

Bracket

Back Box

19-7/16"

(49.4 cm)

23-49/64" (60.4 cm)

18-1/2" (47 cm)

14-13/16"

(

37.6 cm

)

3-3/10"

(8.4 cm)

WARNING: This product can expose you to chemicals

including lead, which are known to the State of California to

cause cancer or birth defects or other reproductive harm. For

more information go to www.P65Warnings.ca.gov.

Produktspecifikationer