StarTech.com ET91000LC Bruksanvisning

Läs gratis den bruksanvisning för StarTech.com ET91000LC (2 sidor) i kategorin Inte kategoriserad. Guiden har ansetts hjälpsam av 30 personer och har ett genomsnittsbetyg på 4.6 stjärnor baserat på 2 recensioner. Har du en fråga om StarTech.com ET91000LC eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Instruction Manual

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

Manual Revision: 02/23/2011

For the most up-to-date information, please visit: www.startech.com

Packaging Contents

• 1 x Fiber Media Converter

• 1 x Power Adapter

• 1 x Instruction Manual

System Requirements

• Multi Mode ber cable

• Cat5e or better UTP Ethernet cable

• Gigabit network infrastructure

• Available AC electrical outlet

ET91000LC / ET91000LCGB / ET91000LCEU

ET91000SC

Gigabit Multi Mode Fiber/Ethernet Media Converter

Installation

1. Connect the ber network cable to the LC connector on the ber

media converter. Using UTP Ethernet cable, connect the cable to

the RJ45 jack.

2. Set the Auto/Force switch on the media converter, to turn

auto negotiate on or o. If set to Force, set the Duplex

switch (full/half) according to the specications of your

networking equipment.

3. The following example illustrates the connection scheme

when connecting from a 1000Base-T Ethernet port of a hub/

switch to a 1000Base-SX/LX port of another hub/switch,

through the ber media converter:

4. The following example illustrates the connection scheme

when connecting from a 1000Base-T Ethernet port on a hub/

switch to a 1000BASE-T Ethernet Network Interface Card

(NIC) in a computer through the ber media converter:

DIP Switch Conguration

Full/ Half:

The Fiber and UTP Duplex will be congured in Full duplex or Half

duplex.

NOTE: This switch includes an “Auto Reset” function so the power-

reset is not necessary when any modication is made here.

LBT:

Loop-back test and get remote side status:

(OFF = Not Active, ON = Active).

NOTE: If the local side loop-back test is active, then LEDs (except

PWR) will all blink rapidly and refresh to display the remote side

status.

LLF:

Link Loss Forwarding (OFF = Not active, On = Active)

Auto/Force:

Auto negotiate duplex mode, or force Full/Half via DIP switches.

LED Conguration

LEDNameStatusDescription

PWRPower

ONUnit is powered

OFFUnit is not powered

BlinkLBT mode enabled

FullDuplex Mode

ONFiber side Full Duplex Mode

OFFHalf Duplex Mode

FXFiber Link

ONFiber link is detected

OFFFiber link is not detected

BlinkFiber activity

LBT

Loop-back

Test/Get CPE

status

BlinkMode enabled

OFFMode disabled

LLF

Link Loss

Forwarding

ONMode enabled

OFFMode disabled

TXEthernet Link

ONUTP link is detected

OFFUTP link is not detected

BlinkUTP activity

*ET91000LC shown

Produktspecifikationer