Varo MOTSA07EL Bruksanvisning
Läs gratis den bruksanvisning för Varo MOTSA07EL (2 sidor) i kategorin Valv. Guiden har ansetts hjälpsam av 35 personer och har ett genomsnittsbetyg på 4.9 stjärnor baserat på 18 recensioner. Har du en fråga om Varo MOTSA07EL eller vill du ställa frågor till andra användare av produkten? Ställ en fråga
Sida 1/2
MOTKC48EL - MOTSA07EL EN
Copyright © VARO www.varo.com 2012 NV Page | 1
OPERATING INSTRUCTIONS
CAUTION: Do not keep the keys in the safe.
1 OPENING THE SAFE FOR THE FIRST TIME
To open the safe for the rst time, remove the small central cover Z (see diagram 2) between “ ”
knob and keypad, insert the key into the lock and turn it counter-clockwise, at the same time,
turn the doorknob clockwise and open the door.
2 INSTALLING THE BATTERIES
The safe requires 4x size (1.5V) batteries. “AA”
The batteries compartment Y (see diagram 1) is located on the back of the door. Remove the “ ”
battery cover and install the batteries into the compartment. Ensure the batteries are fitted with
the correct corresponding polarity.
Once the batteries are installed, close the battery compartment.
3 PROGRAMMING THE CODE
A. Remove the battery cover pand ress the red button “X” inside the battery compartment (see
diagram 1), release it and you will hear two beeps.
B. Now press from 3 to 8 numbers that you wish to use as a combination, and conrm by
pressing the letter “B” within 15 seconds. Or you have to do from the beginning.
C. Write down your new combination immediately and check whether your new combination
has been programmed or not on conditions of the safe door open.
4 USING YOUR SAFE
To open the safe, enter your personal code and confirm by pressing the letter “A”. You will
hear a beep and the green light will be on, then open the door using the knob within 5 seconds.
If you or an intruder uses the incorrect group of numbers, it will not open. If the incorrect
combination is used 3 times consecutively, you must wait for 20 seconds before reattempting.
If again the incorrect combination is selected 3 times, you must wait approximately 5 minutes
before reattempting access.
5 BATTERY REPLACEMENT WARNING
If the batteries are low, the red light (in the left) will warn you immediately.
To test the batteries, just input your personal numbers to open the door. If the batteries are
low, the red light will be on. If nothing happens, it means that batteries are in order.
6 REPLACING THE BATTERIES
The safe requires 4× size “AA” (1.5V/R06) batteries. Open the safe, push the battery cover
plate “Y”(see diagram 1) on the back of the door and replace the 4 PCS old batteries. You
must reprogram the code, using the above third step.
Use of alkaline batteries is recommended.
7 OVERRIDE INSTRUCTION TO OPEN THE SAFE
For your convenience, we have engineered a manual override system for your safe. If you
forget or misplace your combination, remove the small central plate diagram 2) on the “Z “(see
front panel, insert the key into the keyhole and turn it in a counter-clockwise direction, then
turn the knob in a clockwise direction towards the right. This will manually open your safe at
any time.
Produktspecifikationer
| Varumärke: | Varo |
| Kategori: | Valv |
| Modell: | MOTSA07EL |
Behöver du hjälp?
Om du behöver hjälp med Varo MOTSA07EL ställ en fråga nedan och andra användare kommer att svara dig
Valv Varo Manualer
15 September 2024
14 September 2024
23 Augusti 2024
20 Augusti 2024
12 Augusti 2024
31 Juli 2024
29 Juli 2024
Valv Manualer
- Renkforce
- Guzzanti
- Burg-Wachter
- Phoenix
- Steren
- Sentry
- Royal Safe
- Topcraft
- Sistec
- Fichero
- MSW
- Workzone
- Kogan
- Handson
- Toolland
Nyaste Valv Manualer
1 April 2025
1 April 2025
1 April 2025
1 April 2025
1 April 2025
27 Mars 2025
1 Februari 2025
9 Januari 2025
7 Januari 2025
1 Januari 2025