Velleman KNS6 Bruksanvisning

Läs gratis den bruksanvisning för Velleman KNS6 (8 sidor) i kategorin Leksaker. Guiden har ansetts hjälpsam av 46 personer och har ett genomsnittsbetyg på 4.2 stjärnor baserat på 2 recensioner. Har du en fråga om Velleman KNS6 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

KNS6 VELLEMAN 1

KNS6 – TRAINMECH

1. Introduction & Characteristics

Thank you for buying the KNS6 ! Read this manual carefully before bringing the KNS6 into use.

• Familiarise yourself with the operation of transmissions steered through gears or pulleys.

• Easy to build, no glue or soldering required.

• Dislodge the pre-cut pieces when you need them and not before. Sand the jagged edges before use (sandpaper

included)

• The kit is powered by 2 AA-batteries (not included).

The kits of the KNS-series are supplied with prepunched boards, a gearbox, gears, shafts, a switch, a motor, a

battery holder and all necessary parts.

Note that the figures with the assembly instructions can be found in the second folder “KNS6 – Figures”!!!

2. Parts List

Part n° Quant. Description Part n°Quant. Description

1 1 gearbox 17 2 pulley (15 x 1.9mm)

2 1 battery holder 18 2 nylon post (H = 6mm)

3 1 motor DC 6V 19 8 nylon post (H = 3mm)

4 20 1 slide switch with wire 3 PVC tube (15 x 1.5mm)

5 21 1 metal shaft (2 x 40mm) 8 nut M3

6 22 1 metal shaft (3 x 52mm) 4 screw (3 x 12mm)

7 23 5 metal shaft (2 x 60mm) 2 screw (3 x 16mm)

8 24 1 pinion gear 10T (white) 2 screw (3 x 20mm)

9 25 1 face gear (36T/14T) 8 washer (3.2 x 10 x 0.5mm)

10 1 gear 36T/0T 26 32 self-tapping screw (2 x 4mm)

11 1 gear (36T/14T) 27 2 self-tapping screw (2 x 6mm)

12 1 gear (36T/14T) 28 10 nylon pad (5.6 x 4.8 x 1.95mm)

13 29 1 wire with terminal (yellow) 10 nylon pad (Ø8mm)

14 30 1 wire with terminal (green) 10 nylon pad (6.6 x 4.8 x 2.1mm)

15 2 belt (40 x 1.2mm) 31 8 nylon connector (N-shaped)

16 32 2 pulley (15 x 2.9mm) 13 fixing plate (L-shaped)

3. Prepunched Boards (see “KNS6 – Figures

”

)

4. Assembly (see also “KNS6 – Figures

”

)

Fig. 3 : The gears (n°9/10/11/12) should be placed to the left of the pinion gear (n°8). Note that the protruding

edge should point towards the metal case.

Fig. 4 : Screw 1 x piece n°32 on boards 1 & 2 and attach them to boards n°3 & 4.

Produktspecifikationer