Shure PS9 Bruksanvisning

Läs gratis den bruksanvisning för Shure PS9 (5 sidor) i kategorin ej kategoriserat. Guiden har ansetts hjälpsam av 3 personer och har ett genomsnittsbetyg på 4.1 stjärnor baserat på 2 recensioner. Har du en fråga om Shure PS9 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Sida 1/5
1/5
PS9 -- Battery Eliminator
General Description
The PS9 takes the place of a 9V battery, allowing you to connect a PS4 AC adaptor to the following Shure body
pack receivers and transmitters:
P2R
P4R
P4HW
T1
T1G
UT1
ULX1
MX1BP
Shure Incorporated
2/5
The PS9 also works with the VP3 cameramount receiver.
To install the PS9:
1. Turn off the bodypack.
2. Open the battery door and remove the 9V battery.
3. Remove the battery door as follows: with the battery door flipped open, grip its base by the edges and squeeze
firmly while twisting and pulling it out.
4. Insert the flexible door as follows: dock one of the pegs at the base of the door into the side of the battery com
partment, as shown in Figure one. Then firmly squeeze the bottom edges of the door together while twisting it
and pressing in.
Once this door is installed it is not necessary to change back to the original door in order to use a 9V battery.
5. Insert the PS9 into the battery compartment, observing proper polarity.
6. Close the flexible door, lifting the rubber plug to allow the threaded DC connector to extend outward.
7. Attach the PS42 locking connector to the PS9 threaded DC connector, as shown in Figure two.
8. Plug the PS42 into a power source.
9. Turn the bodypack on and confirm that it is working.
Do not attach a 9V battery to the PS9. It is not a battery charger and this may damage the PS9.
Shure Incorporated
3/5
Figure 1

Produktspecifikationer

Varumärke: Shure
Kategori: ej kategoriserat
Modell: PS9

Behöver du hjälp?

Om du behöver hjälp med Shure PS9 ställ en fråga nedan och andra användare kommer att svara dig