Gira 091300 Bruksanvisning

Gira Smarth hem 091300

Läs gratis den bruksanvisning för Gira 091300 (6 sidor) i kategorin Smarth hem. Guiden har ansetts hjälpsam av 6 personer och har ett genomsnittsbetyg på 4.4 stjärnor baserat på 3.5 recensioner. Har du en fråga om Gira 091300 eller vill du ställa frågor till andra användare av produkten? Ställ en fråga

Ladda ner PDF

Sida 1/6

Wind sensor Standard

Order No. : 0913 00

Operating instructions

1 Safety instructions

Electrical equipment may only be installed and fitted by electrically skilled persons.

Serious injuries, fire or property damage possible. Please read and follow manual fully.

Danger of electric shock. Always disconnect before carrying out work on the devise or

load. At the same time, take into account all circuit breakers that supply dangerous

voltage to the device or load.

Danger of electric shock. Not suitable for controlling 24 V Venetian blind inserts. If there

is a fault, 230 V might enter the 24 V network.

These instructions are an integral part of the product, and must remain with the end

customer.

2 Device components

Figure 1

1/6

82523842 07.08.2014

Wind sensor Standard

Blind control system

Figure 2

(1) Evaluation unit

(2) Test LED

(3) Housing lid screws

(4) Wind sensor

3 Function

Intended use

- The evaluation unit and wind sensor are used to protect a blind/shutter against destruction

due to excessively strong winds. The blind/shutter is moved to a safe end position and

locked there until the wind drops below the set wind speed value.

- The evaluation unit is operated together with a Venetian blind insert or binary inputs of the

KNX system.

- Surface-mounted devices for outdoor installation

Product characteristics

- Detection and evaluation of wind speeds

- 8 wind speeds can be set

- The wind alarm is triggered 15 seconds after the set wind speed threshold value is

exceeded

- Test operation for function testing

4 Information for electrically skilled persons

4.1 Fitting and electrical connection

Mounting and connecting the wind sensor

oMount the wind sensor on the roof or on the wall of a house. It must be attached at a

position suitable for wind speed measurement.

Do not mount it in the wind shadow and ensure mounting in the correct position (Figure 2).

oConnect wind sensor to the "+" and "-" terminals (7) of the evaluation unit. Use a shielded

cable for this. Recommendation: JY-ST-Y 2x0.6.

iSensor cables run SELV low voltages acc. to IEC 60364-4-41. When connecting the wind

encoder, ensure safe separation.

82523842 07.08.2014

2/6

Blind control system

Wind sensor Standard

Connecting the evaluation unit

DANGER!

Electrical shock when live parts are touched.

Electrical shocks can be fatal.

Before working on the device, disconnect all the corresponding miniature

circuit breakers. Cover up live parts in the working environment.

oRemove the housing lid of the evaluation unit by slackening the two screws (3).

oFor rear cable insertion, penetrate the rubber seal (6) and insert the cable (Figure 3).

Figure 3: Evaluation unit connection compartment

oFasten the device using two screws (10).

oInsert the cables into the connection housing and connect the according to the connection

diagram (Figure 4).

oIf multiple miniature circuit breakers supply dangerous voltages to the device or load,

couple the miniature circuit breakers or label them with a warning, to ensure release is

guaranteed.

iTerminals 1 and 2 serve as distributor terminals and are not connected inside the device.

They can be used, for example, for a heated wind sensor.

iThe distributor terminal (5) serves to connect the protective conductor.

82523842 07.08.2014

3/6

Blind control system

Wind sensor Standard

Produktspecifikationer

Varumärke:	Gira
Kategori:	Smarth hem
Modell:	091300
Höjd:	160 mm
LED-indikatorer:	Ja
Diameter:	134 mm
Gränssnitt:	Kabel
Modell:	Bägare
Maximal räckvidd:	50 m
Spänning:	230 V
Produktens färg:	Black, White
Ingångsfrekvens:	50 hz
Temperatur vid drift:	-25 - 60 ° C
Internationellt skydd (IP) kod:	IP55
Material, hölje:	Akrylnitrilbutadienstyren (ABS)
Strömkälla av typen:	AC
Strömkälla:	AC
Display inkluderad:	Nej
Vindhastighet mätområde:	3.3 - 24.5 m/s
Vindhastighet mätenheter:	m/s
Väderförhållanden som registreras:	Vindhastighet